激光切割鋁板的切面像切其他材質一樣光滑嗎？鋁板切口一樣也是光滑的，鋁板只是高反光材料，需要大的激光發生器，切割氣體同其他材料一樣，都是用氮氣切割，不會造成表面不光滑的。

Is the cut surface of laser cutting aluminum plate as smooth as cutting other materials? The cutting edge of the aluminum plate is also smooth. The aluminum plate is only a highly reflective material and requires a large laser generator. The cutting gas, like other materials, is cut with nitrogen gas, which will not cause surface roughness.

鋁板采用激光切割特點：

Aluminum plate adopts laser cutting characteristics:

1、切割縫細：激光切割鋁板的割縫一般在0.1mm-0.2mm

1. Cutting seam fine: The laser cutting seam of aluminum plate is generally between 0.1mm-0.2mm

2、切割面光滑：激光切割鋁板的切割面無毛刺無掛渣。

2. Smooth cutting surface: The cutting surface of the laser cut aluminum plate is free of burrs and slag.

3、熱變形小：激光加工的激光割縫細、速度快、能量集中，因此傳到被切割材料上的熱量小，引起材料的變形也非常小。

3. Small thermal deformation: The laser cutting of laser processing is fine, fast, and energy is concentrated, so the heat transmitted to the cut material is small, causing very little deformation of the material.

4、節省材料：激光加工采用電腦編程，激光設備可以把不同形狀的鋁板加工件進行材料的套裁，提高鋁板的材料利用率，節省大量的材料成本。

4. Material saving: Laser processing uses computer programming, and laser equipment can perform material nesting on aluminum plates of different shapes, improving the material utilization rate of aluminum plates and saving a lot of material costs.

5、能切多厚鋁板主要看激光發生器的功率，一般6000W的非常厚能切到16mm，4500W能切到12mm。

5. The thickness of aluminum plate that can be cut mainly depends on the power of the laser generator. Generally, the thickest aluminum plate can be cut to 16mm for 6000W, and 12mm for 4500W.